Is Your Hay Too Hot? (TABLE REVISION)

Much hay has been made in Indiana the last two weeks and much forage remains to be harvested. It is important to package hay at the correct moisture content to avoid excessive heating of bales when in storage. Target moisture to begin baling hay without an effective preservative is 20 percent, 18 percent and 17 percent for small rectangular bales, large round bales, and large rectangular bales, respectively. Excessive heating can result in mold formation by microorganisms, the binding of amino acids to soluble sugars that results in reduced available protein, reduced forage quality, and the possibility of storage structure fires.

 

Moldy hay caused by microorganisms because hay was made at too high a moisture content. (Photo credit: Brooke Stefancik, Purdue ANR Educator-Sullivan County)

Moldy hay caused by microorganisms because hay was made at too high a moisture content. (Photo credit: Brooke Stefancik, Purdue ANR Educator-Sullivan County)

It is quite normal for a temperature rise to occur after hay is packaged, but anything greater than 125 degrees F should be intently monitored. My observation has been that hay producers are watchful of the possibility of “hot” hay for several days after it is put into storage. After this time, the hay may be assumed to be okay and not monitored again. With hay storage structure fires, it may take three to four weeks before spontaneous combustion occurs. It is important to note temperature for an extended period of time and not just for a few days.

 

Hay in the foreground was removed from the hoop building because it was smoldering. (Photo Credit: Keith Johnson)

Hay in the foreground was removed from the hoop building because it was smoldering. (Photo Credit: Keith Johnson)

Temperature probes are available through many agricultural vendors. An online search will provide many resources to consider. The probe should be strong so it can penetrate through tightly packed bales to a length of around six feet preferred. Options for making a probe that permits thermometer insertion on a string can also be found with an online search.

The following table provides temperature values and action steps that should be considered when hay is put into storage.

Critical temperature and action steps for hay in storage.
125°F Or Lower Action Steps
125°F No action needed.
150°F Entering the danger zone. Check temperature twice daily. If possible, disassemble stacked hay to allow more air to move around and cool heated bales.
160°F Reaching the danger zone. Check temperature every couple of hours. If possible, disassemble stacked hay to allow more air to move around and cool heated bales.
175°F Hot spots or fire pockets are likely. Continue to check temperature frequently. If possible, stop all air movement around hay. Alert fire service of possible hay fire incident.
190°F  Fire is likely. Remove hot hay with fire service assistance. The fire service should be prepared for the hay to burst into flames as it contacts fresh air.
200°F or higher Fire is imminent. Remove hot hay with fire service assistance. The fire service should be prepared for the hay to burst into flames as it contacts fresh air.
Source: Extinguishing Fires in Silos and Hay Mows (Natural Resource, Agriculture, and Engineering Service publication NRAES-18).

Much effort goes into the production of high quality hay. Don’t let the effort “go up in smoke”!

Share This Article
It is the policy of the Purdue University that all persons have equal opportunity and access to its educational programs, services, activities, and facilities without regard to race, religion, color, sex, age, national origin or ancestry, marital status, parental status, sexual orientation, disability or status as a veteran. Purdue is an Affirmative Action Institution. This material may be available in alternative formats. 1-888-EXT-INFO Disclaimer: Reference to products in this publication is not intended to be an endorsement to the exclusion of others which may have similar uses. Any person using products listed in this publication assumes full responsibility for their use in accordance with current directions of the manufacturer.
Pest&Crop newsletter - Department of Entomology Purdue University 901 Mitch Daniels Blvd West Lafayette, IN 47907

© 2024 Purdue University | An equal access/equal opportunity university | Copyright Complaints | Maintained by Pest&Crop newsletter

If you have trouble accessing this page because of a disability, please contact Pest&Crop newsletter at luck@purdue.edu.